WHITESIDE RFT5125 - 1/2" SPIRAL FLUSH TRIM W 1-1/4" CEL tt-Hogger The good balance between elasticity

The good balance between elasticity and density in the foam contributes to the final result

or for slats and louvers

Captures dust and chips for easy disposal

Requires 14mm cutter

Gear Change

WHITESIDE RFT5125 - 1/2" SPIRAL FLUSH TRIM W 1-1/4" CEL tt-Hogger The good balance between elasticityProviding state of the art results in flush trimming. The bit uses a double ball bearing pilot to run against your project template while the up cut flutes pull chips up and away from the router, leaving a smooth bottom surface. Materials: Natural woods, composites, hard plastics, thin aluminum Recommended RPM: 16,000 18,000 (max 24,000)