Motor Driver HAT for Raspberry Pi, I2C Interface Spacers/Standoffs ArduPlane manual

ArduPlane manual

One of the modes of the LED Tail board is an "OFF" mode that turns all LEDs off

and real-time features benefited from CAN protocol

14 ADC Channels at 12-bit Resolution

and an adjustable installation angle 0 to 25°

Motor Driver HAT for Raspberry Pi, I2C Interface Spacers/Standoffs ArduPlane manualKey Features Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards I2C controlled, by setting 5 address jumpers, it is stackable up to 32 this modules Onboard PCA9685 chip, provides 12 bit hardware PWM to adjust motor speed Onboard TB6612FNG dual H bridge motor driver, high efficiency, low heating Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal Reserved I2C control