Flanges for waveguides - General requirements Ingestion-build-141043 considering adopted solutions and operation

considering adopted solutions and operation rules (defined by tradition and/or depending on constraints concerning continuity and quality of voltage supply defined by a national regulator)

—  the following shaft support blocks:

Technical conditions of delivery

Who is BS EN 60512-16-16 - Torsional strength of connectors for

Characteristics of contactors

Flanges for waveguides - General requirements Ingestion-build-141043 considering adopted solutions and operation1 Scope This part of IEC 60154 specifies the dimensions of waveguide flanges for use in electronic equipment. It covers requirements for flanges drilled before or after mounting on waveguides. It should be noted that for optimum electrical performance, post drilling of the alignment holes after mounting is recommended. The aim of this standard is to specify for waveguide flanges the mechanical requirements necessary to ensure compatibility and, as far