Heat shrinkable low and medium voltage moulded shapes - General requirements (IEC 62677-1:2017) Ingestion-build-223009 TPEG-PTI) is assigned a unique

TPEG-PTI) is assigned a unique number that is called the Application IDentification (AID)

Annex A (normative) Ruling sections for the mechanical properties

ISO 204 is concerned with the method used to measure such material behaviour

BS EN 14286:2008 Aluminium and aluminium alloys

rectifier diodes) or controllable (i

Heat shrinkable low and medium voltage moulded shapes - General requirements (IEC 62677-1:2017) Ingestion-build-223009 TPEG-PTI) is assigned a unique1 Scope This document is applicable to heat shrinkable low and medium voltage moulded shapes in a range of configurations and materials suitable for insulation, environmental sealing, mechanical protection, electrical conductance, anti tracking and strain relief for power cable terminations, joints and stop ends. It specifies the test methods and material requirements. The most commonly available shapes are as shown in the Annex A. Materials which