E3D V6 Heater Block for Sensor Cartridges CR10 This genuine E3D V6 full

This genuine E3D V6 full metal hot end comes pre-assembled from E3D themselves

- "Direct to Bowden" adds a push-fit connector on side B for configurations where the extruder is in the middle of a Bowden Tube style setup

Fits Wanhao i3 Only

so please check out the properties page

High mechanical strength and excellent flexibility

E3D V6 Heater Block for Sensor Cartridges CR10 This genuine E3D V6 fullThis heater block works with our New Standard thermistor sensor for V6 Along with our other temperature sensor cartridges, this now allows you easily swap to use our high temperature, high accuracy PT100 temperature sensors on your E3D v6 HotEnd, or a Type K Thermistor cartridge, instead of a thermistor. These heater blocks are extremely similar to the standard E3D v6 heater block, but instead of a hole sized for a thermistor with a clamping washer