Rubber, vulcanized. Determination of creep in compression or shear has-digital BS EN 4060 is part

BS EN 4060 is part of the series of EN metallic material standards for aerospace applications

BS IEC 61892-2:2019 supersedes BS IEC 61892‑2:2012

and a maximum platform height of 5 m

Note 1: The method is applicable when the ply surfaces are approximately plane or when they are in the form of a cylinder having an internal diameter greater than approximately 50 mm

BS 448-1 gives recommended practice for the preparation of drawings for inclusion in this Publication

Rubber, vulcanized. Determination of creep in compression or shear has-digital BS EN 4060 is partWhat is ISO 8013 Creep in compression or shear about ? ISO 8013 specifies a method for the determination of creep in vulcanized rubber continuously subjected to compressive or to shear forces. The standard cannot be used for intermittent deformation of rubber. The calibration schedule given in ISO 8013 has been compiled by listing all of the parameters specified in the test method, together with the specified requirement. A parameter and requirement