Technical drawings. General principles of presentation - Basic conventions for cuts and sections Ingestion-build-82396 This technology is mainly intended

This technology is mainly intended for use with simple sensors and actuators in factory automation

or their components

7 Sampling and sample preparation

Testers of such chairs

The design of structural products shall ensure their fitness for the particular application

Technical drawings. General principles of presentation - Basic conventions for cuts and sections Ingestion-build-82396 This technology is mainly intended1 Scope This part of ISO 128 specifies the general principles for presenting cuts and sections applicable to all kinds of technical drawings (mechanical, electrical, architectural, civil engineering, etc.) following the orthographic projection methods specified in ISO 5456 2. For areas on cuts and sections, representation is according to ISO 128 50. Attention has also been given in this part of ISO 128 to the requirements of reproduction, including